Daily maintenance of the mold

1. After the mold is used for a long time, the cutting edge must be sharpened, and the cutting edge surface must be demagnetized after grinding. The mold user company must make detailed records, count its use, care (lubrication, cleaning, rust prevention) and damage, based on which parts and components have been damaged, and the degree of wear, so as to provide information on discovering and solving problems. And the molding process parameters of the mold and the materials used in the product to shorten the trial run time of the mold and improve the production efficiency. Under the normal operation of the injection molding machine and the mold, the various properties of the mold should be tested, and the dimensions of the final molded plastic part should be measured. The current state of the mold can be determined through this information, and the cavity, core, cooling system, and According to the information provided by the plastic part, the damage of the parting surface, etc. can be used to determine the damage state of the mold and the repair measures.

2. Springs and other elastic parts are most vulnerable to damage during use, and they usually appear to be broken and deformed. The method adopted is replacement. During the replacement process, you must pay attention to the specification and model of the spring. The specification and model of the spring are confirmed by the three items of color, outer diameter and length. Only when the three items are the same can they be replaced. The quality of imported spring is better.

3. The punch is prone to breaking, bending and gnawing during the use of the mold, and the punch sleeve is generally gnawed. The damage of the punch and sleeve is generally replaced with parts of the same specification. The parameters of the punch mainly include the size of the working part, the size of the installation part, and the length dimension.

4. Fasten parts, check whether the fastened parts are loose or damaged. The method adopted is to find the parts of the same specification for replacement.

5. Material pressure parts such as material pressure plates, Uniglue, etc., discharge parts such as stripper plates, pneumatic ejectors, etc. During maintenance, check the relationship between the parts of each part and whether there is damage, repair the damaged part, check whether there is air leakage in the pneumatic jacking, and take measures for the specific situation. If the trachea is damaged, replace it. It is necessary to focus on tracking and testing several important parts of the mold: the ejector and guide parts are used to ensure the opening and closing movement of the mold and the ejection of the plastic part. If any part of the mold is stuck due to damage, it will cause production to stop, so it should be kept frequently. Lubrication of the mold thimble and guide post (the most suitable lubricant should be selected), and regularly check whether the thimble, guide post, etc. are deformed and surface damage, once found, they must be replaced in time; after completing a production cycle, the working surface of the mold must be , Moving and guiding parts are coated with professional anti-rust oil, and special attention should be paid to the protection of the elastic strength of the bearing parts of gears, rack molds and spring molds to ensure that they are always in the best working condition; as the production time continues , The cooling channel is easy to deposit scale, rust, silt and algae, so that the cross-section of the cooling channel is reduced, the cooling channel is narrowed, and the heat exchange rate between the coolant and the mold is greatly reduced, and the production cost of the enterprise is increased. Therefore, the cleaning of the flow channel Attention should be paid; for the hot runner mold, the maintenance of the heating and control system is helpful to prevent the occurrence of production failures, so it is particularly important.