Maintenance method of mold accessories (1)

Regular maintenance of mold parts plays a vital role in the service life of the mold. The annual maintenance program required for each injection molding location depends on the different mold cycle cycles. The following are some mold parts maintenance techniques that can be used by each mold user to ensure the effective operation of mold components such as hot runners, heaters, guide pins, thimbles, and molding inserts to prevent accidents.
1. Check whether there is an early warning of rust or moisture at the air diffuser. If you find rust or moisture near the hot runner exhaust hole, it means internal condensation or the water pipe may be broken. Humidity can cause a fatal short circuit to the heater. If the machine is not running all year round and needs to be shut down at night or on weekends, then the chance of this kind of condensation will increase.
2. Remember to remind the operator not to "clean up" the hot nozzle at the gate. If the operator happens to see a small piece of stainless steel at the nozzle of the mold, it may be a nozzle component. "Cleaning up" this seemingly obstructive thing often ruins the hot mouth. In order not to damage the hot nozzle, please confirm the nozzle type of the hot runner system before taking any action, and make sure that all operators are well-trained to recognize the different types of nozzles you touch.
3. Slide stop buckle. For machines that operate all year round, this work should be done once a week. And the end of the year is a good time to carry out a routine lubrication maintenance for these parts.
4. Cross-check the resistance value of the heater. You should have measured the resistance value of the heater when you first started using it, and the end of the year is when you measure and compare it again. If the resistance value fluctuates by ±10%, consider replacing the heater to ensure that it will not fail at a critical moment in the production process. If the initial resistance value has never been measured, measure it once and use the obtained value as reference data for future inspections of the heater.